Radio S-OFF

WORK IN PROGRESS NOT DONE YET And scotty2 did it again!

Howto (Overview of the steps)

1. Perm root your phone

2. Make a backup of partition 7 of your phone

3. Use a custom kernel and the appropriate wp-this module to get rid of the write protection of the radio partitions

4. Copy the image of partition 7 to your PC and modify it with a HEX-editor, push it back to phone and copy it to the partition 7

At this point in time the @secu_flag is removed from your phone and you can run certain AT@SIMLOCK commands.

5. start hboot, attach a serial console to it and start rtask c

6. attach a serial console to the now running AT-command interpreter and run AT@SIMLOCK=3,2 to write the subsidy data clear text to partition 7

4 Enable @secu_flag=0 in partition 7

adb push mmcblk0p7-new.img /sdcard/

insmod /sdcard/wpthis-cyanogen.ko
dd if=/sdcard/mmcblk0p7-new.img of=/dev/block/mmcblk0p7
sync

Wait a minute to make sure that the changes stick

5 start rtask c in hboot

sudo modprobe -r usbserial
sudo modprobe usbserial vendor=0x0BB4 product=0x0C94
sudo screen /dev/ttyUSB0

rtask c

This will terminate your console session. Attach the serial to the new USB-device

sudo modprobe -r usbserial
sudo modprobe usbserial vendor=0x05c6 product=0x9002
sudo screen /dev/ttyUSB2

In the following code there is mixed commands and answers. You only type the commands the start with AT.

ATE1
ATV1
AT@CID?
@CID: 11111111

OK
AT@SIMLOCK?AA
@secu_flag: 0

OK
AT@SIMLOCK=3,8
AT@SIMLOCK=3,2
ERROR
AT@SIMLOCK=3,1
ERROR
AT@SIMLOCK=3,2
ERROR
AT@SIMLOCK=3,4
OK
AT@SIMLOCK=3,8
ERROR
AT@SIMLOCK=3,10
OK
AT@SIMLOCK=3,1
ERROR
AT@SIMLOCK=3,2
ERROR

}}}