| Version 5 (modified by , 5 years ago) (diff) |
|---|
Mycroft Mark II
body / case
The original mark2 body at https://github.com/MycroftAI/hardware-mycroft-mark-II-rpi was not printable on my FDM printer. So I used this: https://community.mycroft.ai/t/simplified-mark-ii-body-for-fdm-printing/8248/12 or https://github.com/guhl/hardware-mycroft-mark-II-rpi
Software basis
I used the picroft image Picroft_Buster-Keaton_2020-01-10.img as the software basis
Audio
I had two problems related to audio.
First the volume of the Adafruit MAX9744 Amplifier was very high and resulted in a general cracking and static noise when switched on.
And in addition the volume control did not influence the volume of the Mycroft output
